德州电梯门套线厂家今日要和我们解说的是电梯门套的装置步骤是什么，你看到这篇文章，就是你的侥幸。dtmtx1689

Dezhou elevator door line manufacturer today is going to explain to us what the steps of the elevator door installation are. You see this article is your fluke.

1、在墙面上覆上一面层,常用的是3MM的三合板,木匠板,好点是防火石塑线条。用气钉把它们钉在墙面上,并用沙纸将板面清洁洁净。

1, on the wall to cover a layer, commonly used is 3MM's three ply board, carpenter board, the good point is fireproof stone and plastic line. Nail them on the wall with air nails and clean the boards with sandpaper.

2、锯板,将UV高光装饰板按实践要求锯成一块块的。

3、倒边,即将装置的UV板四边用倒边机倒成45度角。依据实践装置要求,有的只需倒上下两头或是三个边。

4、清洁电梯门套的反面,用沙纸和抹布将UV板反面清洁洁净。

5、把万能胶或木匠胶均匀涂在UV板反面,然后将UV板平整地贴在墙面上,再用手悄悄锤打UV板,让UV板愈加牢固粘在墙面上。

5, a carpenter or carpenter glue evenly coated on the back of the UV board, and then the UV board flat on the wall, and then quietly hammered UV board hand, so that the UV board more firmly adhered to the wall.

6、调水性填缝料,然后将填缝料填在两张UV板45度角相交处,先填满,再用木板垂直角从45度角相交处悄悄划过,这样相交处就美观了。

6, water adjustment filling material, and then fill the filling in the two UV plate 45 degree angle intersection, first fill, then the board vertical angle from 45 degrees angle cross section quietly, so the intersection is beautiful.

7、清洁电梯套的外表,将剩余的填缝料清洁洁净。

7. Clean the appearance of the elevator sleeve and clean the remaining sealants.