电梯门套施工方案是怎样的呢？下面小编为您讲解一下：
The elevator door construction plan is? Below Xiaobian for you to explain:
一、石材表面处理，石材表面应干燥，含水不大于8%。
First, stone surface treatment, stone surface should be dry, water content is not greater than 8%.
二、石材安装前先对石材进行挑选、使用一个门套石材色泽、花纹一致、挑出色差。
Two, before installation of stone stone selection, use a stone door colors and patterns, pick out the color.
三、对安装石材的结构表面清理，放水平线、垂直线。
Three, the installation of stone structure surface cleaning, put horizontal line, vertical line.
四、用台钻打眼、每块板上、下面打眼，孔位打在板中间，孔径为8mm,深度为12mm。
Four, with a bench drill, each plate, drill holes in the below, the middle of the board, aperture of 8mm, depth of 12mm.
五、用膨胀螺栓把角架固定，再把挂件固定在角架上。
Five, with expansion bolt angle frame fixed, then hang fixed on the corner frame.
六、石材开槽，用大理石胶把石材固定在挂件上。
Six, stone slotted, with marble glue to stone fixed on the pendant.
七、立面垂直，光面平整，接缝平直，接缝宽度，偏差允许2mm。
Seven, vertical, smooth smooth, straight seam, seam width, allowable deviation of 2mm.
八、全部安装完后，要对表面石材一次性清理。
Eight, after all installation, to the surface stone disposable cleaning.
我们用智慧和热情全力为客户生产最优良的产品，您的满意是我们不懈的追求。
We use wisdom and enthusiasm to produce the best products for customers, your satisfaction is our relentless pursuit.