石塑UV板翻新打磨前先勾缝，然后做防水，再做填缝，目的是使到石塑UV板尽可能少吸水，达到降低石塑UV板吸水律，条件允许的情况下最后再做一次防水。

Stone plastic UV board reconditioned and polished before pointing first, then do waterproofing, sealing to make to the stone plastic UV board as far as possible to reduce water absorption, to reduce the stone plastic UV absorbent plate law, the allowable conditions finally do a waterproof.

粗磨：石塑UV板在研磨前先沟缝再做防水，然后填缝。待防水效果出来后，使用金钢石树脂硬磨块，粗磨给水量记住不能太多，每道磨片磨完用拖把拖干净，要彻底吸干水，检查剪口研磨留下的深划道是否用50#磨片磨掉，以此类推，机器走井字研磨，粗磨占整体研磨45%时间，是确保工程竣工质量验收的关健环节。
Coarse grinding: grinding stone plastic UV board in the first groove seam water again, then filling. After the waterproof effect, using diamond resin abrasive block, coarse grinding to water remember not too much, each grinding mill finish mop clean, to completely drain the water, check the shear mouth grinding leave deep scratch if slices 50# wear off and, by analogy, the machine shaft grinding, coarse grinding accounted for the overall grinding 45% of the time, is to ensure the completion of the project, the key link of the quality acceptance.
细磨：后研磨前先再做防水，等防水效果出来后，使用金钢石树脂软水磨片，细磨占整体研35%时间，细磨到2000#后光泽度可达50度。
Fine grinding: grinding before doing waterproof, waterproof effect, using diamond resin soft grinding, fine grinding accounted for the overall development of 35% of the time, fine grinding to 2000# backlight Ze of up to 50 degrees.
精磨：研磨前石塑UV板必须有70%的干燥，先用石塑UV板填封剂作前处理，使到石塑UV板在填补疏松同时也强化了材质。精磨后光泽度提升很高，石塑UV板表面密度提高了，为抛光剂打下坚实的基础，增强了抛光材料的附着力。
Grinding: grinding stone plastic UV board must be 70% dry, first stone plastic UV board filling and sealing agent for pretreatment, to the stone plastic UV board in fills the loose and also to strengthen the material. After polishing, the gloss is improved very high, and the surface density of UV plate is improved, which is the base of polishing agent, and the adhesion of polishing material is enhanced.
抛光：抛光石塑UV板必须是彻底干燥的，使用晶面机功率2HP以上，导入乳Q5进行抛光研磨，抛光后石塑UV板表面光泽度可达最少，90-100度以上。
Polishing, polishing stone plastic UV board must is completely dry, use crystal face power 2HP above, import milk Q5 for grinding and polishing, polishing Houshi plastic boards UV gloss surface can reach at least, 90-100 degrees above.
本文由仿大理石线条友情为您提供，更多的精彩内容请点击：http://haohui.winbrand.cc欢迎您的访问。
In this article, we will provide you with the imitation of marble lines. Please click: http://haohui.winbrand.cc welcome your visit.