现在，电梯是非常普遍的,也是经常被大家使用的,但是大家对于电梯门套的了解少的有点可怜,例如：石塑电梯门套的做法是怎么样的，很多人就会摇摇头不知道了。
Now, the elevator is very common, is also often used by everyone, but everyone's understanding to the elevator door cover less a bit poor, such as: stone what is the model of elevator door cover, a lot of people will don't know the shook his head.

下面就给大家分享一下石塑电梯门套的做法

Below to share to everyone in stone elevator door cover

第一、物料的准备:线条、泡棉胶、硅酮胶、切割锯、胶枪、红外线仪器等。
First, material: line, foam rubber, silicone rubber, cutting saw, glue guns, infrared instruments, etc.
第二、结构墙体基面清理干净表面没有油污、浮尘、并检验墙面平整度和垂直度。

Second, the structure wall base clean surface oil pollution, dust, and no inspection wall roughness and verticality.

超差部分应剔凿或用水泥砂浆修补缺陷,加固找平,方能施工,在墙面找出水平线、垂直控制线。

Out-of-tolerance part should be picked chisel or to repair the defect with cement mortar, reinforcement leveling, before construction, the wall to find a horizontal line, perpendicular line.

第三、电梯门套切割锯采用45度角对线条切割并对角拼接检查平整度,线条背面点粘硅酮胶。

Third, elevator door cover with 45 degree Angle to the line cutting cutting saws and diagonal stitching inspection flatness, lines on the back of the silicone rubber.

第四、将线条安装到位,压实。并用夹具国定,将对角处缝隙打玻璃胶填满抹平,将线条与墙的间隙打胶抹平。
Fourth, the line is installed, compaction. And fixture national will play glass glue to fill diagonal crevice, the clearance between the wall and the line with glue.

第五、整体完工。

Fifth, the overall completion.