首先，在墙面上覆上一面基层，常用的是3MM的三合板，木工板，好点是防火玻镁板。用气钉把它们钉在墙面上，并用沙纸将板面清洁干净。锯板，将UV高光装饰板按实际要求锯成一块块的。倒边，将要安装的UV板四边用倒边机倒成45度角。根据实际安装要求，有的只需倒上下两边或是三个边。

First of all, the wall is covered with a basic level, is commonly used in the three 3MM plywood, wood panels, a good point is the fire glass magnesium board. Gas nail nail them on the wall, and the clean surface with sandpaper. Board cutting, UV high light decorative plate according to the actual requirements of sawn pieces. Upside down, the UV board will be installed on the side with the inverted edge down to 45 degrees. According to the actual installation requirements, and some only need to fall on either side or three sides.

其次，清洁仿大理石UV板背面，用沙纸和抹布将UV板背面清洁干净。把万能胶或木工胶均匀涂在UV板背面，然后将UV板平整地贴在墙面上，再用手轻轻锤打UV板，让UV板更加牢固粘在墙面上。调水性填缝料，然后将填缝料填在两张UV板45度角相交处，先填满，再用木板垂直角从45度角相交处轻轻划过，这样相交处就美观了。
Secondly, on the back of the clean UV imitation marble board, with sandpaper and cloth to clean the back plate UV. The carpentry or all-purpose adhesive glue evenly coated on the UV plate on the back, and the UV plate is flat and affixed to the wall, and then gently hammering UV board, UV board more firmly glued to the wall. Water diversion of filler and filler filled in two UV board at a 45 degree angle intersection to fill, reoccupy board vertical angle from the 45 degree angle intersect at gently across. This intersection appearance on the.
最后，清洁仿大理石UV板表面，将多余的填缝料清洁干净。
Finally, clean the surface of imitation marble UV plate, the excess sealant clean.
本文来自：仿大理石uv板更多的精彩内容请点击我们的官方网站： http://www.jnhaohui.com我们将竭尽全力为您解决，欢迎咨询。
This article from: imitation marble UV board more wonderful content please click on our official website: http://www.jnhaohui.com we will try our best to solve for you, welcome to consult.