讲解一下电梯门套施工注意事项，下面小编为您讲解一下：
Explain the construction elevator door notices, the following small for you to explain:
1.在安装电梯门套时，想要将各层需要的石材挑选好。根据尺寸、颜色和花纹来搭配，然后搬运到各个楼层需要使用的地方。
1 in the elevator door installation, to each layer of stone selection. According to size, color and pattern to match, and then transported to the floor where the need to use.
2.在安装时要注意石材的纹理，尽量保持色泽一致，纹理连贯。安装完成之后，电梯门套的美观性才会最佳。
2 in the installation should pay attention to the texture of the stone, as far as possible to maintain consistent color, texture coherence. After the installation is complete, the appearance of the elevator door will be the best.
3.弹线的时候要仔细测量，不仅一个门套要做好垂直和平整性，每个门套之间也要注意这些问题。
When the 3 bomb line must be measured carefully, not only a door to do vertical integration of peace, we should pay attention to these problems between each.
4.在安装侧板和线条时，要保证至少有2个挂件作为支撑件。安装角钢的位置要测量精确，在中间增加一个加固点的点位。这样做是为了让门套石材更加稳定、牢固。
4 in the installation side and lines, to ensure that at least 2 pendant as support. The installation angle of the position to increase the measurement accuracy, a reinforcement point in the middle. This is done in order to make more stable and solid stone door.
5.安装电梯门套时不要靠得太紧，在电梯门框边预留5mm到8mm的位置，注意让四周的预留位保持一致。
5 when the elevator installation door and don't get too tight in the elevator door post reserved for the 5mm to the 8mm position, pay attention to the surrounding the reservation is consistent.
6.在安装电梯门的槛石时，地砖和电梯框边要有3mm左右的坡度，门框边和顶面石材外口要有2mm左右的斜度。
6 in the installation of the elevator door sill stone, floor tiles and lift frame edge is about 3mm to slope, and the top surface of the doorframe side stone mouth about 2mm slope.
7.顶面线条碰和侧面线条的角度为45°，碰角做到严密、平整，施工时注意缝隙内不留余胶。如果有余胶就及时清理掉，然后使用勾缝剂处理。线条大小一致，造型稳合整体风格。
7 the top surface of the line and the side of the line angle of 45 degrees, the impact angle to be tight, smooth, pay attention to the construction of the gap does not leave any glue. If you have time to clean out the glue, and then use the pointing agent. The size of the same line, the shape of the overall style.
8.在使用云石胶打点之后，还要使用专用的AB胶固定，这样才能确保稳定性。
8 after using the marble glue dot, but also the use of special adhesive fixed, so as to ensure the stability of.
9.电梯门套全部安装完成后，即使进行现场清理工作，还有做好调色勾缝处理。还要注意对石材阳角的保护，用泡沫护角将它包裹起来。这样能避免受到碰撞损坏。
9 elevator door all the installation is complete, even on-site clean-up work, and good color pointing processing. Should pay attention to the protection of Stone Yang angle, foam corner will wrap it up. This can avoid collision damage.
好了，小编今天就为大家简单介绍到这里啦！明天的咨询会更精彩哦！请大家不要错过哦！
Well, Xiao Bian today for everyone to introduce here! Tomorrow's consultation will be more exciting oh! Please do not miss oh!