1、先要在墙面上覆上一面基层，常用的是3MM的三合板，木工板，好点是防火玻镁板。用气钉把它们钉在墙面上，并用沙纸将板面清洁干净。
1, the first to be covered on the wall of the grass, the commonly used 3MM three plywood, wood panels, good point is the fire glass magnesium board. Gas nail nail them on the wall, and the clean surface with sandpaper.
2、锯板，将UV板安实际要求锯成一块块的。
2, saw plate, UV plate of an actual requirement of sawn pieces.
3、倒边，将要安装的UV板四边用倒边机倒成45度角。根据实际安装要求，有的只需倒上下两边或是三个边。
3, the reverse side, will be installed on the side of the UV board with the inverted edge machine down to 45 degrees. According to the actual installation requirements, and some only need to fall on either side or three sides.
4、清洁UV板背面，用沙纸和抹布将UV板背面清洁干净。
4, clean the UV plate with sandpaper and back cloth to clean the board back UV.

5、将万能胶或木工胶均匀涂在UV板背面，然后将UV板平整地贴在墙面上，再用手轻轻捶打UV板，让UV板好好牢固粘在墙面上。
5, will be in carpentry or all-purpose adhesive glue evenly painted UV board back, then UV plate is flat and affixed to the wall, and then gently beat UV board, UV board to take firmly glued to the wall.
6、调水性填缝料，然后将填缝料填在两张UV板45度角相交处，先填满，再用木板垂直角从45度角相交处轻轻划过，这样45度相交处就好看了。
6, water gap filling material, then filling material filled in the two UV board at a 45 degree angle intersection to fill, reoccupy board vertical angle from the 45 degree angle intersect at gently across, such 45 degrees at the intersection of the good.
7、清洁UV板表面，将多余的填缝料清洁干净。
7, clean the surface of the UV board, the excess sealant clean.
本文由仿大理石uv板提供帮助，更多的相关内容请点击：http://www.jnhaohui.com我们将详情为您解答.欢迎您的光临!
In this paper, the imitation marble UV board to provide help, more relevant content please click: http://www.jnhaohui.com we will be the details for you to answer!