电梯套线条厂家分享电梯的运行问题通常源于组成部件脏污、润滑不良，以及配合间隙和相对位置因紧固螺栓松动、磨损等而发生变化。下面就给大家分享一下电梯的保养策略。

The elevator sets line manufacturers share the elevator operation problems usually originate from the components of dirty, poor lubrication, and the clearance and relative position of the fastening bolts loosening, wear and other changes. Let's share with you the elevator maintenance strategy.

第一、电梯的大部分组件安装在井道、底坑及轿厢外部，密封条件不是很高，很容易被井道里对流空气中的灰尘脏污。轿门和厅门地坎、滑轨、吊门轮和滑块及门锁等部件因乘客的频繁进出、空气中的尘埃和地毯中的细纤维等脏污得更快，造成机构动作受阻，电气触头接触不良。
First, most of the components of the elevator are installed in the well, bottom pit and the outside of the car. The sealing condition is not very high. It is easy to be dirty by the dust in the convective air in the well. Sedan doors and hall doors, slippery rails, hoist wheels and sliders and door locks, such as the frequent entry and exit of the passengers, the dust in the air and the fine fiber in the carpet are quicker, resulting in the obstruction of the mechanism and the poor contact of electrical contacts.

第二、电梯在运行过程中，由于频繁的启停和换向运行所产生的冲击力，使转动部件的磨损加快。如轴承的磨损、制动带的磨损、蜗轮蜗秆的啮合面磨损、曳引轮轮槽与曳引绳的磨损、导靴靴衬的磨损及门机系统、门锁、吊门轮和滑块的磨损等。除制动带和导靴靴衬易损件需定期更换外，各机械部件都必须保持良好的润滑，以避免转动部件的直接摩擦。有的电梯之所以出现“抱轴”、断轴事故，均属无润滑所致。

Second. During the operation of the elevator, the wear and tear of the rotating parts are accelerated due to the frequent impact of starting and stopping and reversing operation. Such as wear of bearing, wear of brake belt, wear of meshing surface of worm and worm, wear of traction wheel groove and traction rope, wear of guide shoe lining, door machine system, door lock, hanging door wheel and slide block wear and so on. Apart from the need to replace the worn parts of the brake belt and the boot boot regularly, all mechanical parts must be kept lubricated to avoid direct friction of the rotating parts. Some elevators appear to have "axle holding" and shaft breaking accidents, which are all caused by no lubrication.

第三、组成电梯的机构有好几十种，这些部件因经常受力，就易出现紧固部件松动，致使机构动作难以准确到位而出现运行故障。为了使部件正常工作，必须定期检查其配合间隙和相对位置的精度，及时紧固松动的零部件，更换已磨损超差的构件。

Third, there are dozens of organizations that make up the elevator. Because of the constant force of these components, the fastening components are easily loosened, which makes the movement of the mechanism difficult to be accurately in place. In order to make the parts work properly, the precision of the matching clearance and relative position must be checked regularly. The loose parts should be fastened in time and the worn and super poor components should be replaced.

电梯套线条厂家温馨提醒：电梯的日常维护保养，主要是做好清洁保养、润滑保养和调整紧固这三项工作，电梯运行的安全性就提高很大，故障率也是明显降低。

Elevator line manufacturers warm remind: the elevator's daily maintenance, the main is to do a good job of cleaning and maintenance, lubrication and adjustment fastening these three work, the safety of the elevator operation is greatly improved, the failure rate is also significantly reduced.